![]() Check your solder joints! It's a good idea to reheat and reflow all of the ones you did, just to be sure. ![]() If you're still having trouble, try reinstalling them. Are you using the latest FTDI drivers? Install them if not.Is the cable plugged into a USB hub? That can sometimes cause trouble.For the original ArduPilot and ArduIMU, choose "Arduino Duemilanove". If you've got an ATMega2560 chip, select "Arduino Mega 2560". Are you selecting the right board? For ArduPilotMega, if your board uses an ATMega1280 processor (the big chip on the APM board will say "ATmega1280") select "Arduino Mega (Atmega1280)".Did you check the "Set RTS on close" box in the Windows Com port, as instructed in the manual?.Here are the most common causes and things to check. (or any other error report when uploading code, aside from the obvious ones like compile errors or choosing the wrong serial port) ![]() If you're trying to upload code with Arduino and you get an error message that looks something like this:Īvrdude: stk500_getsync(): not in sync: resp=0x78Īvrdude: stk500_disable(): protocol error, expect=0x14, resp=0x78" Posted by Chris Anderson on Decemat 3:00pm
0 Comments
Leave a Reply. |